Saturday, February 13, 2021

Pocket Bushman continued

 This is a short post to show the work I did on the Cold Steel pocket bushman. The first photo shows the knife with the lock removed. When i have to work on a knife with the blade still attached such as this one I double the masking tape on the cutting edge. This makes it fairly safe but caution is still important. I use the little antique soap dish for my parts holder. In it are the stud and screw for the lock along with the spring.



This next photo shows the lock bar after I stoned the edges that were dragging against the inside of the handle. It shows as a mirror polish in the photo. The edges of the long cutout were stoned, too. This removed any wire edge or roughness from the manufacturing process. I ran green rouge on a felt wheel over everything with the Dremel tool after I cleaned off the oil and left over stone material. After I got everything back together (a real chore in itself! That little spring is strong and you have to put it all back together a certain way) the knife opened and closed a bit easier. I had to tighten the screw on the blade as it was a tiny bit wobbly. That took care of it.


 

This last photo shows some of my coarser stones. These are from machinist supply companies. I use them to smooth up and polish knife and gun parts. If you know what you're doing you can make a revolver work so smooth it sings!



No comments:

Post a Comment

Please feel free to comment! I will answer any questions you have.